• Your position:Home > News Center
  • PRODUCT

    CONTACT US

    Rugao Tongda Machinery Manufacturing Co., Ltd.
    Add.:No. 64, Shili Road, Rucheng Street, Rugao City, Jiangsu Province,China
    Contact:Mr. Zhu
    Tel:0513-87625525
    Fax:0513-87635595
    Mob:13806274600
    E-mail:zhuhao365@163.com

    Kneading machine installation and maintenance

    For the welding type positioning, before the user purchases the machine, after pouring the foundation, six 20cmx20cm carbon steel intermediate plates corrected by the horizontal square are poured into the foundation, and the machine is moved to the prefabricated foundation. The site can be directly welded to the six square irons cast on the foundation. The welding fixing method is called common. Our company will weld the whole set of equipment on the metal frame, and the user does not need to install it, which is very convenient.

    1. After the kneading machine is installed, first clean, decontaminate and wipe the anti-rust grease. Check each lubrication point and inject lubricant (fat).

    2. Check the tightening of the V-belt before driving, and move the motor to the appropriate position by adjusting the bolt.

    3. Check if the fastener is loose, if the steam pipe leaks, and whether the circuit and electrical equipment are safe. Electric heating type kneading machine must have grounding device

    4. Clean the kneading machine room before the test, and run for 10-15 minutes to confirm that the machine is running normally and then put into production. Usually, the new machine gear (including the reducer) has a large noise at the initial use, and naturally decreases when it is to be engaged for a while.

    5. When using steam to warm, the inlet pipe should be equipped with safety valve and pressure gauge, and the steam pressure should not exceed the pressure requirement of the mixing tank of the sign knowledge.

    6. Reduce the use of reversal when mixing the slurry.

    7. The lubrication parts should be oiled frequently.

      8. There should be no leakage of raw materials in the wall plate seal.

      9. The belt is tightly fitted and regularly checked for adjustment or replacement.

    10. The steam pipe is not allowed to leak, the valve should be closed when the machine is deactivated, and the reliability of the safety valve pressure gauge is guaranteed.


    HOME
    TEL
    SMS
    CONTACT